Analog sensor electronics requires special care during design in order to increase the quality and precision of the signal, and the life time of the product. Nevertheless, it can experience static deviations due to the manufacturing tolerances, and dynamic deviations due to operating in non-ideal environment. Therefore, the advanced applications such as MEMS technology employs calibration loop to deal with the deviations, but unfortunately, it is considered only in the digital domain, which cannot cope with all the analog deviations such as saturation of the analog signal, etc. On the other hand, rapid-prototyping is essential to decrease the development time, and the cost of the products for small quantities. Recently, evolvable hardware has been developed with the motivation to cope with the mentioned sensor electronic problems. However the industrial specifications and requirements are not considered in the hardware learning loop. Indeed, it minimizes the error between the required output and the real output generated due to given test signal. The aim of this thesis is to synthesize the generic organic-computing sensor electronics and return hardware with predictable behavior for embedded system applications that gains the industrial acceptance; therefore, the hardware topology is constrained to the standard hardware topologies, the hardware standard specifications are included in the optimization, and hierarchical optimization are abstracted from the synthesis tools to evolve first the building blocks, then evolve the abstract level that employs these optimized blocks. On the other hand, measuring some of the industrial specifications needs expensive equipments and some others are time consuming which is not fortunate for embedded system applications. Therefore, the novel approach "mixtrinsic multi-objective optimization" is proposed that simulates/estimates the set of the specifications that is hard to be measured due to the cost or time requirements, while it measures intrinsically the set of the specifications that has high sensitivity to deviations. These approaches succeed to optimize the hardware to meet the industrial specifications with low cost measurement setup which is essential for embedded system applications.
The present thesis deals with multi-user mobile radio systems, and more specifically, the downlinks (DL) of such systems. As a key demand on future mobile radio systems, they should enable highest possible spectrum and energy efficiency. It is well known that, in principle, the utilization of multi-antennas in the form of MIMO systems, offers considerable potential to meet this demand. Concerning the energy issue, the DL is more critical than the uplink. This is due to the growing importance of wireless Internet applications, in which the DL data rates and, consequently, the radiated DL energies tend to be substantially higher than the corresponding uplink quantities. In this thesis, precoding schemes for MIMO multi-user mobile radio DLs are considered, where, in order to keep the complexity of the mobile terminals as low as possible, the rationale receiver orientation (RO) is adopted, with the main focus to further reduce the required transmit energy in such systems. Unfortunately, besides the mentioned low receiver complexity, conventional RO schemes, such as Transmit Zero Forcing (TxZF), do not offer any transmit energy reductions as compared to conventional transmitter oriented schemes. Therefore, the main goal of this thesis is the design and analysis of precoding schemes in which such transmit energy reductions become feasible - under virtually maintaining the low receiver complexity - by means of replacing the conventional unique mappings by the selectable representations of the data. Concerning the channel access scheme, Orthogonal Frequency Division Multiplex (OFDM) is presently being favored as the most promising candidate in the standardization process of the enhanced 3G and forthcoming 4G systems, because it allows a very flexible resource allocation and low receiver complexity. Receiver oriented MIMO OFDM multi-user downlink transmission, in which channel equalization is already performed in the transmitter of the access point, further contributes to low receiver complexity in the mobile terminals. For these reasons, OFDM is adopted in the target system of the considered receiver oriented precoding schemes. In the precoding schemes considered the knowledge of channel state information (CSI) in the access point in the form of the channel matrix is essential. Independently of the applied duplexing schemes FDD or TDD, the provision of this information to the access point is always erroneous. However, it is shown that the impact of such deviations not only scales with the variance of the channel estimation errors, but also with the required transmit energies. Accordingly, the reduced transmit energies of the precoding schemes with selectable data representation also have the advantage of a reduced sensitivity to imperfect knowledge of CSI. In fact, these two advantages are coupled with each other.