Refine
Has Fulltext
- yes (13)
Keywords
- hydraulics (2)
- Ausfallwahrscheinlichkeit (1)
- Automatic Differentiation (1)
- Customer distribution (1)
- Datenerfassung und -auswertung (1)
- Elastic BVP (1)
- FEM (1)
- Fahrzeugprüfstände (1)
- Festigkeitsverteilung (1)
- Hydraulik (1)
Faculty / Organisational entity
Safety and reliability requirements on the one side and short development cycles, low costs and lightweight design on the other side are two competing aspects of truck engineering. For safety critical components essentially no failures can be tolerated within the target mileage of a truck. For other components the goals are to stay below certain predefined failure rates. Reducing weight or cost of structures often also reduces strength and reliability. The requirements on the strength, however, strongly depend on the loads in actual customer usage. Without sufficient knowledge of these loads one needs large safety factors, limiting possible weight or cost reduction potentials. There are a lot of different quantities influencing the loads acting on the vehicle in actual usage. These ‘influencing quantities’ are, for example, the road quality, the driver, traffic conditions, the mission (long haulage, distribution or construction site), and the geographic region. Thus there is a need for statistical methods to model the load distribution with all its variability, which in turn can be used for the derivation of testing specifications.
In this paper, the model of Köttgen, Barkey and Socie, which corrects the elastic stress and strain tensor histories at notches of a metallic specimen under non-proportional loading, is improved. It can be used in connection with any multiaxial s -e -law of incremental plasticity. For the correction model, we introduce a constraint for the strain components that goes back to the work of Hoffmann and Seeger. Parameter identification for the improved model is performed by Automatic Differentiation and an established least squares algorithm. The results agree accurately both with transient FE computations and notch strain measurements.
Optimal control methods for the calculation of invariant excitation signals for multibody systems
(2010)
Input signals are needed for the numerical simulation of vehicle multibody systems. With these input data, the equations of motion can be integrated numerically and some output quantities can be calculated from the simulation results. In this work we consider the corresponding inverse problem: We assume that some reference output signals are available, typically gained by measurement and focus on the task to derive the input signals that produce the desired reference output in a suitable sense. If the input data is invariant, i.e., independent of the specific system, it can be transferred and used to excite other system variants. This problem can be formulated as optimal control problem. We discuss solution approaches from optimal control theory, their applicability to this special problem class and give some simulation results.